Hi,
I recently started to invoke Synchronize It! directly from TotalCommander. This is highly convenient. I somehow didn't find a parameter to choose "include subfolders -> include all folders" (which usually is my default setting). Currently, I use the following parameters:
"%P\" "%T\" /sync /R /XD"" /smart
/XD"" (exclude no folders) kind of does the trick of making sure no subfolders are filtered or excluded. But it would be nicer if there was a parameter to directly choose "include all folders". Maybe it's already there and I am just blind
Thank you and best regards
- spitfire
Command Line Parameter for "Include all folders"
-
- Posts: 84
- Joined: Mon May 21, 2007 9:11 am
- Location: Basel, Switzerland
Re: Command Line Parameter for "Include all folders"
No, you are not blind this is default state, so there is no switch for this. But as you correctly pointed out, if last session of used with filter, there is no way to clear it. I will add some switch for this.
-
- Posts: 84
- Joined: Mon May 21, 2007 9:11 am
- Location: Basel, Switzerland
Re: Command Line Parameter for "Include all folders"
Great, thank you very much!